Home Automation 53A00-2, Руководство по установке

Страница: 13 / 20

11
Brightness (0-50): Adjusts the brightness level of the touchscreen display.
Backlight Timeout (0-14):
Sets the length of time (in minutes) that the touchscreen display
remains illuminated after the last time a button is pressed on the
touchscreen.
After the time has expired, the touchscreen display turns off.
Simply touch anywhere on the screen and the display will
immediately illuminate.
A setting of “0” means the touchscreen is always illuminated
(“0” is not a recommended setting).
Ambient Setting:
Sets the “light” and “dark” ambient light levels (see “Ambient
Setting” in this document for additional information).
Calibrate
If the touch targets on the touchscreen appear to be offset from the buttons, the touchscreen can
recalibrated by pressing the [Calibrate] button. Use a stylist or other object with a dull point, to
touch the center of each of the 5 tick marks (+). They will appear in the following order:
Center, Top Left, Lower Left, Lower Right, and Top Right.
Once all five tick marks have been touched, touch anywhere on the screen to return to the
Screen Setup page. Check the touch target accuracy. Recalibrate if necessary.
Ambient Setting
The Ambient Setting is used to brighten the touchscreen display in an illuminated room and dim
the touchscreen display in a dark room. When changing from a light setting to dark (e.g. the
lights in the room are turned off), the touchscreen will maintain its “light” setting until 30
seconds after the room is darkened. When changing from a dark setting to light (e.g. the lights
in a dark room are turned on), the touchscreen will immediately change to its “light” setting.
To set the “light” and “dark” settings, with the room illuminated set the “Brightness” setting for
optimal viewing of the display, then press the [Light] icon. Then, darken the room (e.g. turn off
the lights or wait until the sun goes down) and set the “Brightness” setting for optimal viewable
of the display, then press the [Dark] icon.
Note: The “Brightness” level must be set higher for the ambient “light” setting, than the
“Brightness” level set for the ambient “dark” setting.