Page 19
GDW45S 45cm Freestanding Dishwasher User Manual
Start of Dishwasher
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
Attention:
The following things should be checked before starting the dishwasher.
1
The dishwasher is level and fixed properly
2
The inlet
water tap
is open
3
Inlet
hose connections are fully tightened and not leaking
4
The
electrical power plug securely fitted to socket
5
The power is switched on
6
The inlet and drain hoses are k
inked and squashed
7
All packing materials and printings should be taken out from the dishwasher
How to Drain Excess Water From Hoses
If
attaching drain hose directly to sink and it is above
1000
mm
high from floor
level
the excess water
in hoses cannot be drained
directly
into the sink. It will be necessary to drain excess water from
hoses into a bowl or suitable
container that is held outside and lower than the sink.
Drainage directly
into sink drain pipes via the dishwasher connection point is the preferred installation method.
Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water
leaks.
Ensure
that the water drain hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than
3
metres; otherwise the cleaning effect of the dishwasher could be reduced.
Syphon Connection
The waste connection must be at
a height less than 1000 mm (maximum) from the bottom of the dish.
The water drain hose should be fixed .
