ASSEMBLY for 6ft Spiral Tree
1 Assembly the Tree Stand
Slide the four legs of the Tree Stand Legs (G) into the Tree Stand
Center Cone (H). Press together firmly until they lock in place.
2 Assembly the Pole Section to the Tree Stand
Insert one of the Pole Section (E) ,with the tapered end up, into the hole
at the top of the Tree Stand Center Cone ((H) connected to the Tree
Stand Legs (G). Attach the other two poles on top of one another and
on top of the first pole.
3 Assembly the Spiral Tree to the Pole Section
Place the Spiral Tree (B) over the Pole Section. Align the center of the
Spiral Tree plastic top to the Top of the Pole Section . Allow the Spiral
Tree to "drop" down to the ground around the Pole Section. The top
pole will stop the top of the Spiral Tree and hold it in place.
4 Assembly the Star Tree Topper to Pole Section.
Place the Plastic Cap (D) on top of the assembled Pole Section with the
Spiral Tree. Insert the bottom of the Star Tree Topper (A) into the top of
the Plastic Cap firmly.
5 Securing the Spiral Tree
Tie the four strings at the bottom of the Spiral Tree (B) to the tip of the
Tree Stand Legs (G) as shown in the diagram below.
6 Outdoor Use: Spiral Tree to the Ground
Replace the Tree Stand with Stake Section (F). Use the Driving Cap (C) ,
if needed, on top of the Base Tree Stand pole by lightly striking it with a
hammer to assist in inserting the Stake end into the ground (Remove
Driving Cap (C) is used); then follow steps 2 to 4 above. Tie the four
strings at the bottom of the Spiral Tree to the Ground Stakes (I). Pull
tightly and stake it to the Ground to secure.
G
H
E
D
