-6-
• Adjust the height of the tabletop. Loosen t e plastic
nut and adjust the tabletop to the height you want.
Tighten the plastic nut.
Step 5
Attach Reflector Studs to Screen Cover
•
Insert 3 Reflector Studs
• Tighten studs securely.
Step 6
Attach Head Assembly to Post
• Screw off 4 small bolts.
• Load Head Assembly by inserting hose into post.
• Insert Head Assembly into post.
• Control knob should be above decal on post.
• Attach Head Assembly to post, and loosely install
four small bolts.
• Tighten bolts securely.
Step 7
Install Reflector
Note: Leave all screws and nuts loose until entire shield
is put together to ensure proper alignment. Tighten
after sections are aligned.
•
Slide two reflector panels together.
• Insert one small screw.
• Attach cap nut and leave loose.
•
Place reflector center plate into middle of reflector
panels and follow same procedure as above.
• Repeat procedure to complete the assembly of all
four sections.
• Fully tighten all of the screws.
WARNING: Remove protective cover before assembly.
