3
1. Turn the thermostat switch to the minimal value, at the same time turn the heat select
switch to the “0” position.
2. Plug in the appliance, and turn the thermostat switch to the maximum position. Then
turn the heat select switch to choose air or warm air and the temperature of warm air as
below. While working the indicator light will be on.
2.1 Turn the heat select switch to “ “position, the heater blows cool air.
2.2 Turn the heat select switch to “I” position, the heater blows warm air, working at Low.
2.3 Turn the heat select switch to “II” position, the heater blows warm air, working at High.
2.4 Turn the heat select switch to “0” position, the heater stops working, the indicator light
will be off.
3. Adjust the thermostat switch to suitable position for desired temperature setting.
3.1 When you feel the room temperature comfortable, turn the thermostat switch anti-
clockwise slowly to the minimal position until the appliance stops working.
3.3 Then the thermostat switch will keep the room temperature at the desired temperature
automatically.
4. Tip over safety switch is designed to switch the heater off in the event that it is lifted
or falls over. If the heater is placed on a very indented surface or on a carpet with
exceptionally long, soft pile the safety switch may prevent the heater from turning on.
Should this happen replace the heater on a firmer, smoother, surface.
5. Oscillation function: The oscillation switch at its back side. Pull the switch to “O”, the
oscillation is working. Pull the switch to “-”, the oscillation stops working.
SECURITY SYSTEM
1. To avoid risk to human being or damage to internal components, the ceramic heater has
a security system which will automatically switch off the appliance if the heat reaches
the safety limit. If overheating occurs:
1.1 Turn the heat select switch to “0” position, turn the thermostat switch to the minimal
position and remove the plug from the socket.
1.2 Check if the air flows smoothly before the outlet and inlet, and if the appliance is put in
right position. If so, get it in order before restart the appliance.
1.3 Let the ceramic heater cool down for at least 10 minutes before you start it again.
1.4 Plug in the appliance and switch it on. If the appliance can't operate normally, remove
the plug immediately from the socket and have the ceramic heater serviced by an
appointed service only.
EN
