24 | EngliSH
8. Troubleshooting
The following points must be taken into account to avoid
personal and material damage when troubleshooting
machine failures:
•
Correct a failure only if you have qualified staff, i.e.
the individual work must be carried out by trained
specialist personnel, e.g. electrical work must be
carried out by a qualified electrician.
•
Always prevent the machine from unintentional
restart by disconnection it from the power supply.
Take appropriate precautionary measures.
•
Ensure the safety shut-down of the machinery by a
second person at all times.
•
Safeguard mobile machinery parts to prevent injuries.
•
Unauthorized changes on the machinery are at own
risk and discharge the manufacturer from any liability!
Further steps for troubleshooting
If the aforementioned points do not help you to eliminate
the fault, contact our customer service. They can help you
as follows:
•
Assistance by telephone or in writing by the
customer service
•
Support on site by the customer service
•
Check/repair of the machinery in the factory
Please note that the use of certain services of our custo-
mer service might incur further costs! Please contact our
customer service for further information.
7. Shutdown
7.1. Final shutdown / storage
Switch off the system, disconnect the machine from the
electricity supply and dismantle and store it. Note the fol-
lowing information concerning storage:
Beware of hot parts!
When removing the machine, be careful of the tem-
perature of the housing components. These can heat
up to well above 40°C. Let the machine cool down to
ambient temperature before you touch it.
•
Clean the machine.
•
Store it in a clean, dry place, protect the machine
against frost.
•
Place it down vertically onto a firm foundation and
secure it against falling.
•
Seal the intake and discharge ports of pumps with
suitable material (such as foil).
•
Support the electric connecting lead on the cable
lead-in to help avoid a permanent deformation.
•
Protect the ends of the electric power cable from
moisture.
•
Protect the machine from direct sunshine as a pre-
ventive measure against brittleness in elastomer
parts and the propeller and casing coating.
•
When storing the machine in a garage please remem-
ber: Radiation and gases which occur during electric
welding destroy the elastomers of the seals.
•
During lengthy periods of storage, regularly (for ex-
ample every six months) turn the impeller or propeller
by hand. This prevents indentations in the bearings
and stops the rotor from rusting up.
7.2. Restarting after an extended period of storage
Before restarting the machine, clean it of dust and oil de-
posits. Then carry out the necessary maintenance actions
(see “Maintenance”). Check that the mechanical shaft
seal is in good order and working properly. Once this work
has been completed, the machine can be installed (see
“Installation”) and connected to the electricity supply by
a specialist. See “Start-up” for instructions on restarting.
Only restart the machine if it is in perfect condition and
ready for operation.
Содержание Flut - Set
Страница 1: ...Original Betriebsanleitung EN Original Instruction Manual NL Originele handleiding Flut Set...
Страница 38: ...38 Notizen Notes...
Страница 39: ...39 Notizen Notes...
