Holzstar DB 900, Инструкция по эксплуатации

Страница: 8 / 16

７
Spurs
q
Remove the faceplate (if factory installed)
(1) from the headstock using the
wrench and push rod (2) provided and
set aside.
q
Insert the headstock spur (3) into the
spindle hole.
q
Install the tailstock live center into the
tailstock hole.
Removal of spurs
q
To remove either the headstock spur or
the tailstock live center insert the push
rod (5) through the back access holes of
the headstock and tailstock.
q
Remove the rod and store it for future
use.
Fig 6
Faceplate Installation
q
Remove the headstock spur from the
spindle by using the push-out rod.
q
Thread the 6
”
diameter faceplate
onto the spindle and tighten with the
supplied wrenches.
q
Mount your workpiece to the
faceplate using flat head brass
screws. Be certain that the ends of
the screws will not interfere with your planned turning.
Extension Bed
q
The extension bed is attached to the
left of the headstock for outboard
faceplate turning when the use of the
articulated tool rest is required.
q
If outboard faceplate turning does
not require the use of the tool rest,
do not attach the extension bed until
required.
q
To attach the extension bed (1) to
the lathe bed, align the bolt holes (2) with the threaded bed holes (3).
q
Install a lock washer (4) onto an Allen bolt (5).