Holzstar DB 900, Инструкция по эксплуатации, Страница: 10 / 16

９
Tailstock
q
Move the tailstock (1) by loosening
the tailstock lock lever (2) and
sliding the tailstock assembly to
the desired position on the lathe
bed. Securely lock the tailstock
into position by tightening the lock
lever.
q
The tailstock spindle (3) can extend up to 2 1/2" from the tailstock
housing. You can move the tailstock spindle by loosening the spindle lock
lever (4) and then rotating the spindle hand wheel (5).
q
Be sure that lock levers (4) and (2) are secure before operating the lathe.
q
The tailstock spindle is hollow and can be accessed from the hand wheel
end. Use the push-out rod to remove the Morse Taper tailstock spindle.
Articulated Tool Rest
q
The articulated tool rest (1) may be
used with or without the extension
arm (2).
q
To move the tool rest base (3)
loosen the lock lever (4) and slide
the tool rest base left or right along
the lathe bed or it may be moved
forward or backwards.
q
When using the tool rest extension
arm you can loosen lock levers (5) and (6) to make any necessary
adjustments.
q
Be certain to tighten all tool rest locking levers before turning on the
lathe.
q
The articulated tool rest may also be repositioned onto the extension bed
for use on outboard turnings.
IMPORTANT: Make sure that the tool rest is adjusted to be as close to the
workpiece as possible. Rotate the workpiece by hand to check the
clearance
before
turning the lathe on.