Holzmann BT 46ECO, Руководство пользователя

Страница: 35 / 63

HOLZMANN MASCHINEN Austria www.holzmann-maschinen.at Strana 35
TALÍŘOVÁ A PÁSOVÁ BRUSKA / BELT AND DISC SANDER BT 46ECO
Belt sander
 Dismantle the worktable (5).
 Rotate the belt sander (9) by 90° upwards.
 Remove the nut (17) using the adjustable wrench and remove the safety fence (11)
(fig.e).
 Remove six screws (19) and remove the lower protective cover (18) (fig.f).
 Operate the clamping lever (7) to relax the sanding belt (20).
 Remove the old sanding belt (20).
 If necessary, clean the guide roller and the belt guide.
 Fit a new sanding belt (20).
 Align the sanding belt (20) and tension using the clamping lever (7).
 Fit the lower protective cover (18) and secure with six screws (19).
The belt must be adjusted after it is fitted to ensure that it travels safely over the guide roller
when in use (fig.g).
 Check whether the guide roller (21) and the long edge of the belt guide rail (22) form a
90° angle. To adjust, turn the knurled screw (8).
 Try the run manual. If the run is still not central, repeat the adjustment.
 Turning on the machine: Press the green button.
 If the belt goes off to the side considerably. Switch the machine off immediately (red
button) and repeat point 1.
 Adjust the direction carefully using the knurled screw (8) until the belt runs straight.
14.3 Operation
14.3.1 Belt sander (fig.h)
The belt sand can be turned through 90°.
 Undo the locknuts (23).
 Rotate the belt sander (9) by 90° upwards as far as it will go.
 Tighten the locknuts (23).
14.3.2 Sanding disc (fig.i)
 Undo the holding nut (4) and adjust the table console (5) to the required angle of tilt. The
set angle can be read off using the scale (24).
 Tighten the holding nut (4) back up again.
14.3.3 ON/OFF (fig.j)
To switch on, push the green button („I‟).
To switch off, push the button („O‟).