Holzmann BS 128HDR, Руководство пользователя

Страница: 35 / 51

OPERATION
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 35
BS 128HDR
13.1.3 Setting the blading speed

Open the lid by tightening the knob and the lid lift.
Now you can use the speed table in the lid to change the cutting
speed.

Turn the pulley easily and the V-belt in the provided disk
groove screw.
CAUTION:
The V-belts must be connected to the opposite wheels always in
the same plane.
13.2 Operation
13.2.1 Setting the feed
The feed can be on the set screw on the Set hydraulic
lowering cylinder ( 4 ).
Select the feed according to the following table.
13.2.2 Adjustment of the miter angle

Loosen the clamping screw ( 5 ).

Now you can move the entire saw arm.

By tightening the clamping screw ( 5 ) that is fixed again.
13.2.3 Clamping the workpiece

Place the workpiece in a vice and tighten it with the hand wheel (7 )
to
13.2.4 Setting the saw band guide

Adjust the guide so that it approximately 2 cm in front of the
workpiece.

Loosen the hand wheel ( 8 ) and slide the guide.

Pull the handwheel back up again
adjusting feed
Knob