HOLZMANN MASCHINEN TS 315SE, Руководство пользователя

Страница: 29 / 39

TROUBLE SHOOTING
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 29
TS 315SE
16 TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
PROBLEM CAUSE SOLUTION
Saw does not start
．
Motor cord or wall cord is not plugged
in
．
Circuit fuse is blown
．
Circuit breaker is tripped
．
Cord or switch is damaged
．
Plug in motor cord or wall cord
．
Replace circuit fuse
．
Reset circuit breaker
．
Have the cord or switch replaced
．
Rip fence does not
move smoothly
．
Rip fence not mounted correctly
．
Rails are dirty or sticky
．
Clamp screw is out of adjustment
．
Remount the rip fence
．
Clean and wax rails
．
Adjust clamp screw
．
Rip fence does not
lock at rear
．
Clamp screw is out of adjustment
．
Adjust clamp screw
．
Cutting binds or burns
work
．
Blade is dull
．
Working is fed too fast
．
Rip fence is misaligned
．
Spreader is out of alignment
．
Wood is warped
．
Replace or sharpen blade
．
Slow the feed rate
．
Align the rip fence
．
Replace the wood
．
Always cut with
convex side to table surface
．
Wood edges away
from rip fence when
ripping
．
Saw does not make
accurate 90ºor 45º
cuts
．
Ripping fence is misaligned
．
Positive stops inside cabinet need
adjusting(Bevel Cuts)
．
Miter gauge is misaligned(Miter Cuts)
．
Check and adjust the rip fence
．
Adjust positive stops
．
Adjust the miter gauge
．
Height/bevel
adjusting handwheel
is hard to turn
．
Gears or post inside cabinet are clogged
with saw dust
．
Clean the gears or screw post
．
Blade makes poor
cuts
．
Blade is dull or dirty
．
Blade is wrong type for cut being made
．
Blade is mounted backwards
．
Clean, sharpen, or replace blade
．
Replace with correct type
．
Remount blade
．
Blade does not lower
when turning height
/bevel adjusting
handwheel
．
Locking lever is not at full left position
．
Move locking lever to left
．
Motor labors in rip
cut
．
Blade not proper for rip out
．
Change blade; rip blade typically has
fewer teeth
．
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
N O T I C E
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the problem.