HOLZMANN MASCHINEN SBO3X, Руководство пользователя

Страница: 14 / 18

ASSEMBLY
HOLZMANN Maschinen GmbH www.holzmann-maschinen.at 14
SBO3X / SBO4X
SBO3X
Mount legs

Join 2 legs so that the serrated parts face each
other (1). Screw the legs together with 1 hex
head screw M8×16, 2 washers 8 mm an 1 safety
nut M8 (2).

Screw the legs additionally with 1 crosshead
screw M6×12, 1 washer 6 mm and a safety nut
M6 in the slotted hole underneath (3).
NOTE: Tighten both safety nuts only so far that the
legs can still be moved.

Repeat this with the 2 other pairs of legs.
Mount cross braces
NOTE: The middle foot can be fixed in 2 positions,
either centrally or off-centre, depending on the
layout, but must be chosen the same for both
sides.
Use crosshead screws M6×12 with washer 6 mm and
nut M6 to mount the cross braces (5, 7).
 Mount the cross brace 4 hole (4) on 2 pairs of
legs (5).

Mount the cross brace 6 hole (6) diagonally on
the same pairs of legs (7).
 Use the hex screw M6×35 with matching
washer 6 mm and nut M6 at the overlap of the
two cross braces (8).
 Repeat this procedure on the opposite side.
NOTE: Tighten all nuts firmly.
SBO4X
Mount legs
 Join 2 legs so that the serrated parts face each
other (1). Screw the legs using a hex head screw
M8×16, 2 washers 8 mm and a safety nut M8 (2).
 Screw the legs additionally with a crosshead screw
M6×12, a washer 6 mm and a safety nut M6 in the
slotted hole below (3).
NOTE: Tighten both safety nuts only so far that the
legs can still be moved.
 Repeat this procedure with the other 3 pairs of
legs.