HOLZMANN MASCHINEN Austria www.holzmann-maschinen.at
Page 44
SOUSTRUH NA KOV ED1000KDIG / METAL TURNING LATHE ED 1000KDIG
13.5.4
Automatc feed
Put the feed / thread lever (6) to the left or right position and the feed engagement lever (26)
into the corresponding. When lever (26) is facing up, longitudinal feed is set. Shows the lever
down, cross feed is selected
13.6
Chuck / faceplate assembly
If you mount the rotary chuck or faceplate want to dismantle or, first make sure that the cam
locks are fixed. To do this, remove the retaining screws and set each button so that the em-
bossed ring is flush with the back of the chuck.
Now mount chuck or faceplate on the spindle head and pull the six cams in order to. If they are
all drawn together, the cam-line should be located on each cam V between the two marks on the
spindle head. If a cam is not entirely within this marker, remove food or faceplate and adjust the
bolt, as shown in the illustration, again. Tighten the retaining screw on each bolt before each use.
Do not replace food or faceplate between different lathes without checking the correct cam lock.
Put the feed / thread lever (6) to the left or right position and the feed engagement lever (26)
into the corresponding. When lever (26) is facing up, longitudinal feed is set. Shows the lever
down, cross feed is selected
13.6.1
Cooling
During rotation, it is very important to cool the workpiece and the tool.
To switch the cooler with a switch I.
Now align the end of the blue hose on the workpiece and turn on the stopcock.
I