page: 22
GB
5.
m
Other risks
The machine has been built using modern technology in accordance with recognized safety rules. Some remaining
hazards, however, may still exist.
• The rotating saw blade can cause injuries to fingers and hands if the work piece is incorrectly fed.
• Danger to health from wood dusts or wood chips.
• Always wear personal protective equipment such as eye protection and dust mask.
• Noise can be a health hazard. The permitted noise level is exceeded when working. Be sure to wear personal protective gear
such as ear protection.
• Hazardous current, when using improper electrical connections.
• Even when all safety measures are taken, some remaining hazards which are not yet evident may still be present.
• Remaining hazards can be minimized by following the instructions in “Safety Precautions“, “Proper Use“ and in the entire operat-
ing manual.
• Defective saw blades can cause injuries. Regularly inspect the structural integrity of saw blades.
• The operating instructions supplied with the special accessories must be observed and carefully read when Scheppach special
accessories are used.
Attention: risk of accident!
The wood must always be seated on both sides of the saw blade on the v-block of the rocker. (see arrows)
Caution Danger of accidents!
Wear safety shoes.
Caution Danger of accidents!
To wear ear protection.
Wear safety glasses.
Accident risk!
Before commissioning instruction
manual read.
Attention!
Tool continues to run after
power disconnected!
Before any maintenance, cleaning
or repair work, disconnect the unit
from the power supply!
For engines equipped with an in-
ternal combustion engine, discon-
nect the spark plug connector!
6. Training of the operator
• Forward the safety instructions to all people working on or with this machine.
• The minimum age for the operating person is 18 years. Trainees should be minimum 16 years of age, but are only allowed to work
with the machine under supervision.
• People running the machine should not be distracted.
• Keep children away from the to the net connected machine.
• Wear tight fitting clothes. Take off jewelry, rings and wristwatches.
• Observe all safety and hazard warnings on the machine and keep it in readable condition.
• Be careful at work: Danger of damaging finger(s) and hand(s) by the rotating cutting tool.
• Regular pauses must be observed during operation.
• Safety shoes and protective clothing must be worn during operation.
