Holybro KOPIS 1, Руководство пользователя и инструкция по установке

Страница: 11 / 42

[Type here] [Type here]
P a g e | 9 KOPIS 1
Binding A FrSky Receiver
For the FrSky XSR, X4R-SB, and XM+ receiver, the binding instructions are as follows.
1. REMOVE THE PROPS from your KOPIS for safety. DO NOT SKIP THIS STEP.
2. In the Taranis, navigate to the Model Setup screen by pressing MENU, PAGE.
3. At the bottom of the Model Setup screen, scroll down to find the “Internal RF” sub -section.
4. Confirm that Mode is set to D16
5. Highlight [BIND] and press the ENT button. BIND will begin flashing and the Taranis will make a
high-pitched beeping (assuming its volume is turned up).
6. If the quadcopter battery is plugged in, un-plug it so that the receiver is powered down.
7. Hold down the BIND/FS button on the receiver. On the XM+ especially, the button is very small
and it can be difficult to depress with your finger. If you use a tool to press the button, be very
gentle so as not to damage the button.
8. While continuing to hold down the BIND/FS button on the receiver, plug in the LiPo to the
quadcopter so that the receiver powers up. It can be helpful to have a friend do this while you
hold down the bind button.
9. Binding will be indicated by the green LED lighting up solid and the red LED blinking.
If binding is not successful, most likely you didn’t fully depress the bind button. In this case, un-plug the
LiPo and repeat steps 6-8.