7
DAILY OPERATION
1. Turn Main On/Off switch to the ON position and variable speed control to the desired
setting.
Allow 30-40 minutes for complete machine warm up.
2. Adjust speed as required during operation to achieve a good bake.
3. When done for the day, turn the On/Off switch to the OFF position. The conveyor
will stop and the elements will go off. The two fans will continue to run to cool the
machine. The fans are controlled by a thermostat and will stop when the elements are
cooled.
POWER SAVER MODE:
During slow periods, switch the unit into the Power Saver Mode by turning ON the
Power Saver Switch. Doing this will reduce the units power consumption by approx.
37%. In the power save mode elements 3,4,7 and 8 on the bottom and elements
3 and 4 on the top are operating. To ensure that you still provide a good bake it is
essential to reduce the Speed Control to compensate for the reduction in power. You
will still be able to provide a toast in 2 minutes in the power saver mode.
Allow 3 minutes for the unit to reach 100% power when turning off the power saver
switch, before increasing the speed control back to its original position.
DO NOT
begin to service or clean the machine until the fans have stopped.
CAUTION:
Some parts of the machine will still be warm.
Refer to the Troubleshooting section if the machine is not performing as expected.
CERTAIN SURFACES ARE EXTREMELY HOT DURING OPERATION AND CARE
SHOULD BE TAKEN WHILE USING THIS UNIT.
CAUTION
SPEED CONTROL
POWER SAVER
SWITCH
MAIN ON/OFF
SWITCH
PILOT LIGHT
IL1346
