7
7
Misting System Assembly & Installation
Misting System Assembly & Installation
Work out the spacing of the misting jets and cut the misting hose to length and
install the relevant misting tees. Finish each line with a misting elbow.
(3 x Misting Elbows are included in this System to enable installation of a single or
multiple line misting solution. More Misting Elbows are available at your nearest
HOLMAN stockist Product Code: MS20003)
Use the hose clamps to attach the misting hose to the wall or beams.
The Holman hose clamps use a very strong masonry nail that should not bend
when you hammer it into timber or masonry.
HINT 1: Run pipework along mortar joints in brickwork.
Hammer the hose clamps into the brickwork for a reliable result.
HINT 2: Use a hose clamp on each side of a misting tee to ensure the tee is firmly
positioned and misting in the correct direction.
HINT 3: If hammering into metal the correct nails will need to be purchased.
HINT 4: Avoid installing the tube in direct sunlight as this may cause the tube
to go brittle over time.
Position Hose Clamps
7-8cm away from
Nozzle
(Hose Clamp)
(Hose Clamp)
(Misting Jet)
Tap
Auto Drain Valve
Misting Tees
with Nozzles
Misting Elbow End
Misting Tube
Curtain of Mist for most effective coverage.
(Illustration shows 5 Misting Tees and 1
Misting Elbow being used as an example of
a basic layout.
Further products to extend your misting
system are available at your local HOLMAN
stockist).
Hose Clamps
Elbow or Tee
Connector
Misting
Tee
Misting
Filter
E. Installing The Misting System
Each section of tube should be
connected before attempting
to pin the system to walls or
beams. Start at the garden tap
or water source point. If you
are using a
Garden Hose
(A)
,
it is recommended that you
install a
Sprinkler Adaptor (C)
into the
Misting Filter (8)
as
shown. Run the tube to the
position you want your first
misting jet in. Use
Tees
or
Elbows
to go around corners
or split the pipe runs. Visit
www.holmanindustries.com.au for
more info on our sprinkler adaptors
A
8
1
C