PAGE 4
OPERATOR'S MANUAL
HOLMAN CONVEYOR TOASTERS
MODEL DT14-M
TROUBLESHOOTING GUIDE
A.
UNIT WILL NOT HEAT, CONVEYOR BELT WILL NOT MOVE.
1. Make sure air intake on bottom of unit is clean.
2. Be sure the main circuit breaker is switched to the
ON
position.
3. Check to see if the toaster is plugged in and all controls are turned to the
ON
position.
B.
UNIT HAS HEAT ONLY ON ONE SIDE, CONVEYOR BELT TURNS FREELY.
1. Call Holman Factory Service Department at
1-800-807-9054
as heating element
may need replacing.
C.
CONVEYOR BELT DOES NOT TURN, HEATER TUBES GET HOT.
To check for mechanical binding:
1. DISCONNECT UNIT FROM POWER SOURCE.
2. Remove screws (2 ea.) holding top cover in place at the rear of the unit.
3. Remove top cover (see page 10).
4. Remove each screw holding side panels in place and lift them up and out.
5. Loosen the four screws that hold the drive motor in place.
6. Slide the motor up allowing the drive chain to be removed from the
sprockets.
7. Move the conveyor belt by hand to check for mechanical binding. If
conveyor moves freely, call the Holman Factory Service Department at
1-800-225-3958 as the drive motor and/or speed control may need replacing.
THE HOLMAN FACTORY SERVICE TEAM IS AVAILABLE 24 HOURS A DAY/7DAYS A WEEK FOR
TECHNACLE ASSISTANCE CALL 1-800-807-9054
OPERATOR'S MANUAL
