connecting to the tap & operation Modes
tap timer Diagram
4
For connection you need a water tap with a 20mm or 25mm thread.
1.
Unscrew the union nut
(3)
to enable the water tap connection
(2)
to move freely.
2.
Screw the tap timer firmly onto the water tap by the tap connection. Turn the unit to face you so the
Control Dials
(4)
can be easily seen.
3.
Screw the Union Nut
(3)
up tight.
4.
Connect your hose to the Snap-on Hose Connection
(7)
.
NOTE:
Screw the connection by hand.
DO NOT
use a wrench. Always keep the Clear Screw-on Cover
(6)
closed on the unit to prevent dirt from getting into the mechanism, preventing operation.
Operation Modes:
This 2 Dial Tap Timer has both Automatic and manual functions. Programming is in
intervals from every hour, to once a week. The minimum run time is 1 minute, up to 120 minutes.
The timer can be manually turned ON and OFF as required.
“How often” Dial
•
Turn the dial to select:
from every hour
to once a week.
•
Select from the
11 positions
or Reset.
NOTE: Fit 2 x 1.5V AAA ALKALINE Batteries (Ensure they are good quality)
CO1701 2 Dial Tap Timer.indd 6
14/11/12 4:34 PM
