4
5
3) Mount the Rain Gauge (G) onto
the plastic bracket (B)
7SHJL[OL9HPU.H\NLPU[V[OLIYHJRL[HUKÄ_[OL
4 bolts and nuts in place. The cover of the Rain
Gauge can be removed by rotating in an anti-
clockwise direction. When replacing the cover it
^PSSVUS`Ä[PUVULWVZP[PVU9V[H[LP[JSVJR^PZL[V
secure the cover in place.
It is important that the cover is secure.
Assembling The Sensor Unit
4) Mount the plastic brackets (A, B & C) onto the stainless steel
mast (D)
Starting at the top, insert the ‘U Shaped’ plastic bracket (A) into the top of the stainless steel pole
+HUKÄ_^P[OHIVS[HUKU\[
Slide plastic bracket (B) with the Rain Gauge onto the pole from the bottom and secure with a
bolt and nut.
Slide the remaining plastic bracket (C) with nothing attached so far, onto the pole from the
bottom and secure with a bolt and nut.
Orientate the brackets A & B to ensure the Rain Gauge is away from the Wind Sensors and
ensure that they do not come into contact. Likewise, the Thermo Hygro Sensor (once attached)
will need to have space and not come into contact with any brackets. Once orientation is good,
make sure all the bolts and nuts are secure.
2) Fit the Wind Direction Sensor
(F) to the other end of the
‘U Shaped’ plastic bracket (A)
and connect the cable (J) from
the Wind Speed Sensor (E)
Insert the cable from the Wind Speed Sensor
(E) into the socket in the base of the Wind
Direction Sensor (F)
.
Insert the Wind Direction
head (F) into the bracket on the other end of the
WHSZ[PJIYHJRL[(HUKÄ_[OLIVS[HUKU\[<ZL
the clips on the bottom of bracket (A) to secure
the cable (J) from the Wind Speed Sensor.
F
G
WS5029 Manual 2020 v4.indd 4
3/9/20 10:17 am
