4
ILLUSTRATED PARTS LIST:
Electronic Control Unit
P/N 534-55
TOOLS / ADDITIONAL MATERIALS REQUIRED FOR INSTALLATION:
The following tools and materials are required to complete the installation:
•
Electric Drill
•
Digital Volt / Ohm Meter (10 Megohm)
•
Miscellaneous Hardware
MOUNTING THE ELECTRONIC CONTROL UNIT (ECU):
DANGER! ALWAYS DISCONNECT YOUR VEHICLE’S BATTERY BEFORE PERFORMING ANY WORK ON THE VEHICLE’S
ELECTRICAL OR FUEL SYSTEM. FAILURE TO DO SO MAY PRODUCE SPARKS, CAUSING A FIRE OR
EXPLOSION, RESULTING IN PROPERTY DAMAGE, PERSONAL INJURY, AND/OR DEATH.
WARNING! Do not open the ECU. The digital electronics contained within this ECU are sensitive to static electricity. Opening
this ECU WILL VOID THE WARRANTY.
WARNING! Do not mount the ECU in an enclosed area such as the glove compartment. Mount the ECU in an area that will
allow air to flow freely across the ECU to dissipate heat generated by the ECU.
WARNING! When mounting the ECU, care must be taken that none of your vehicle’s other systems, such as the electrical
system, air conditioning, or heating components, are damaged by either drilling holes or using mounting screws.
Always check on the other side of the location that is to be drilled to ensure that no damage will occur.
WARNING! Do NOT mount the ECU in the engine compartment. The ECU is not designed for the environment (heat, moisture)
present in the engine compartment. Premature failure of the ECU will result.
WARNING! The
PRO-JECTION
2D system must be appropriately grounded to ensure proper system performance and to
prevent any damage to the system. To ensure a good grounding plane, connect a ground strap between the
engine and the chassis.
The digital ECU is designed to operate in either a small block or a big block mode. The mode in which this ECU operates is selected by
connecting one of the wires in the wiring harness to either ground or a switched positive (+) 12 volt source. Further instructions relative
to this selection are located in P/N 199R-9777-6.
NOTE:
All connections shown MUST be made in order for the
PRO-JECTION
2D
system to operate properly.
1. Pick a suitable location on the interior of the vehicle in which the ECU can be mounted. Ensure that the mounting location allows
for sufficient length of the wiring harness and clearance for connectors and that the adjustment knobs on the front of the ECU are
accessible before mounting the ECU.
2. Using the ECU base plate as a template, drill 4 pilot holes, ensuring that no damage will result to any of your vehicle’s other
systems.
3. Mount the ECU with 4 self-starting sheet metal screws (not included).
