HOLEMAKER HMPRO50, Руководство оператора

Страница: 9 / 22

HMPRO50 OPERATOR’S MANUAL
www.holemaker.com 9
Before you cut
Before positioning the machine on work piece always make sure that:
- work piece is made of ferrous material
- thickness of work piece is adequate for secure magnetic adhesion (mild
steel - 10mm is recommended)
- Ensure no part of magnet overhangs the steel workpiece
- surface of steel under the magnet is flat
- wipe, brush or sand down clean surface where you intended to place the
drilling machine, so that you remove rust, paint, dirt etc which would reduce adhesive
power of the electromagnetic base.
Install annular cutter in the machine before plugging it into mains.
Place the machine so that the tool is over the centre of the hole you intend to make
and turn the magnetic base ON.
Always make sure prior to use that the machine is secured from falling
down with a chain/strap.
9
An example of a safety chain/strap use.