®
HMPRO200A OPERATOR’S MANUAL
10
www.holemaker.com
2.3. Installing, removing, and operating the annular cutter
Install the arbor as described before, wear protective gloves, and then insert the proper pilot
pin into the annular cutter (1, Fig. 5). Use a clean and dry cloth to wipe the cutter. Next, place
the cutter into the arbor (2) in such a way to align the flats 3 with the set screws 4, and then
use the 8 mm hex wrench to tighten both set screws.
To remove the cutter, loosen the screws 4 using the 8 mm hex wrench.
'3
0 4 ('
