Hokkaido HWMI 150 A, Инструкция по установке и эксплуатации

Страница: 13 / 28

- 13 -
OPERATING INSTRUCTIONS
OPERATION INSTRUCTION 7.
Fig. 7-1
Fig. 7-2
Before using this Unit, please follow the steps below.
Filling the Water Tank: if Unit is used for the first time or used again after emptying the tank, please make
sure that the tank is full of water before turning on the power.
Method: see Fig. 7-1.
7.1 Operation steps
Water Flow
Hot water outlet
Close
Water out
Open
Open the cool water inlet and hot
water outlet
When water flows out from the water
outlet, the tank is full.
Turn off the hot water outlet valve
and water flow is finished.
Cool water inlet
Hot water outlet
Open
After powered on, the display lights up. User can operate the Unit through the buttons for selecting different
modes which are displayed.
Emptying: if Unit needs to be cleaned, moved, etc., water tank must be emptied.
Method: see Fig. 7-2.
Operation without water in water tank may result in damage
of auxiliary e-heater.
Due to such damage, the Supplier is not responsible for the
quality issue.
If water temperature exceeds 50°C, this may cause serious
burns and death.
If water temperature is very high, special care should be
paid to children, disabled and aged people.
Emptying
Close
Open
Drainpipe
Open
Cool water inlet
Close the cool water inlet, open the
hot water outlet and open drainpipe.
Hot water outlet
Drainpipe
Close
After emptying, please replace the
nut of drainpipe.
CAUTION
CAUTION