Congratulations and Thank-you for your purchase of Hogtunes RGRM4CH kit
made to install Hogtunes REV 450-RM or NCA 450-RM amp into Rushmore
model Road Glides! If you have any questions or concerns, we are here to
help. Email [email protected] or call us during regular business hours
(EST) at (705)-719-6361. If you still need help, then please consider a
Professional installation by your dealer.
Getting Started:
Step #1: Make sure your ignition switch stays in the “OFF” position. Remove
your outer fairing and headlamp assembly and set aside. Refer to a service
manual if you need help with this. NOTE: Placing a towel on the front fender
can help prevent scratches or “dings” from dropped tools or fasteners, etc.
Colorful expletives will also be kept to a minimum!
Step#2: NCA 450-RM amp comes with a silver mounting plate attached that
needs to be removed. Undo the 4 screws that attach the amp to the plate,
separate the plate from the amp, and re-install the 4 screws back into the
amplifier.
Step#3: Remove the 4 black screws highlighted by the white arrows as shown
in Diagram 1.1 below. Install the plates onto the amp using the factory screws
just removed as shown in Diagram 1.2 below.
End Of Amp With Fuse And
Power Connector
Diagram 1.2
Diagram 1.1
IMPORTANT: Please note the plate that goes on the fuse end of the amp!
The amp will not install properly if you affix plates in wrong location!
