monty 3650
Betriebsanleitung Operator’s Manual Notice d’ utilisation
Modéle:
monty 3650
_DE-EN-FR_ Release December 2018
HOFMANN behält sich das Recht zu Änderungen ohne Vorankündigung vor _ HOFMANN reserves the right of modification without notice _ Document non contractuel
29
2.0 CARRIAGE INSTRUCTIONS
The machine is crated in a wooden box of
appropriate strength.
The box is mounted to the pallet.
Handling of the machine must be made with an
appropriate lifting device (fork lift) (Fig.9).
19
Fig.9
2.1 UNCRATING INSTRUCTIONS
Uncrate the machine paying attention when
removing the nails or during any other operation
which may be hazardous.
After removing the crate check for any visible
damage to the machine and its components.
In case of doubts call qualified personnel for
assistance.
The packing materials (plastic bags ,polystyrene,
nails, screws, wood etc.) must be properly disposed
of.
Place the above mentioned materials into a trash
container and dispose per local regulations.
ALWAYS WEAR GLOVES WHEN
UNCRATING THE MACHINE TO
PREVENT
SCRATCHES
OR
ABRASIONS DUE TO THE CONTACT
WITH PACKING MATERIALS.
2.2 INSTALLATION AREA
Install the machine in a covered and dry area.
The installation of the machine requires a free space
of at least cm 350x350 (12”x12”) (Fig.10).
298
Fig.10
Make sure that from the operating position the user
can see all of the machine and the surrounding
area.
The operator shall forbid, in such an area, the
presence of non authorized persons and of objects
which may create possible hazards.
The machine shall be installed on a horizontal floor
preferably even. Do not install the machine on a
sinking or irregular floor.
In case the machine is installed on a raised floor or
on a service vehicle the floor must have a capacity
of at least 5000 N/m
²
(500 kg/m
²
or 110 lbs x sqft ).
The machine must be secured to the floor through
the holes provided in the cabinet. Expansion screws
12x120 mm (or bolts 12X80mm) shall be used.
Drill 12 mm holes in the floor in correspondence of
the holes provided for in the cabinet.
Place the nogs into the holes drilled in the floor and
move the machine sothat the holes of the cabinet
are in correspondence of the holes in the floor.
Tighten the screws at 70 Nm (51 ftxlb).
Содержание monty 3650
Страница 62: ...62 ...