Instructions for adjustment
Datum 27.04.2005
geodyna 4801P
Page 25 of 30
Compensating for the residual unbalance of the main shaft and the drive disc.
Activate adjustment Code- C84
Remove the calibration rotor from the wheel adaptor
The following reading appears
:
Close the wheel guard and start the extended measurement run by pressing the
START KEY.
The residual unbalance of the main shaft and the drive disc was determined during the
measurement run and is stored into the volatile data memory.
.
Calibration is completed and must be stored by entering Code C90
Or:
Service and test functions become accessible by pressing and holding the
F1 C-CODE KEY
and
by rotating the main shaft.
To ensure that compensation of residual unbalance remains effective after power has been switched
off, the data must be stored to the permanent memories with code C90 (nonvolatile memories).
