Hofmann Megaplan Megaspin 800P_2, Руководство по эксплуатации и обслуживанию

Страница: 12 / 28

12
b b
Use and maintenance manual Rev. 02-2012
ENGLISH
Use of the wheel balancer
Return the MEGASTICK to rest position. The machine has
automatically detected the steel rim mode.
Set the rated width, which is generally
indicated on the rim, or measu re it u sing
the compass gauge (standard accessory)
Press the button
HOME HOME
STOP STOP
to go to the measurement panel
or to perform a measurememt spin.
AUTO SENSE - AUTOMATIC WIDTH MEASU
REMENT (OPTION)
To improve the dimensional calibration of large wheels, such
as off-road vehicles, trucks or wheels protruding far out
from the rim, press the button to select the tyre
projection (1” to 2”).
Lower the guard slowly, after performing automatic
ddiameter measurement.
When the wheelguard is lowered too fast F1 appears on the
monitor. Press and lower the wheelguard once
more but slower.
Perform a measurement spin, turn the wheel to the correct
angles, secure the clip-on weights and perform a control
spin.
To balance more tyres of the same type and dimensions,
the machine automatically stores the data for the current
mounted wheel.
5.2.2 AUTOSELECT for ALUM rims
Slide out the MEGASTICK to the left side, at the point
where an adhesive weight is to be
fi tted. Hold the MEGA-
STICK in this position until a “beep” is heard.
Slide it out further towards the right side and wait for a
second “beep”.
The machine has automatically detected the ALUM mode.
Return the MEGASTICK to rest position
Perform a measurement spin.
For the adhesive weight in the left position, turn the wheel
to the correct angle, secure the weight in the clamp with the
adhesive facing upwards and slide out the MEGASTICK
until a “beep” is heard.Push the clamp upwards until the
weight adheres to the wheel.
Return the MEGASTICK to the rest position and proceed
for the right position in the same way.
Indicator of LT function
enabled
Indicator of WIDTH
SONAR function enabled