Hobym Observatory Crux170HD, Руководство пользователя

Страница: 15 / 44

HOBYM Observatory
15
How to Set Up in Alt-Azimuth Mode
1.
After the installation in the same manner as
the equatorial mode, loosen the altitude
holding handle to some extent and set the
right ascension to 90 degrees. There is an M8
tapped hole on the left side of the body.
Through this tap hole to match the hole inside.
2.
Insert the supplied M8 Knob bolt into the
tapped hole and tighten it clockwise. After
that, tighten the altitude adjustment handle as
much as possible.
3.
Determine the telescope’s approximate
center of mass. This is to minimize the load
on the equator during operation.
4.
After the declination head points north,
the telescope points west. Then we put the
weight on the end as shown below.