Hobot HOBOT-2S, Руководство пользователя

Страница: 12 / 16

- 10 -
2. Replacing the Water Tank
(1) Remove the screws with a Phillips
screwdriver.
(2) Remove the old water tank by sliding it
upwards, then disconnect the cable from
HOBOT.
(3) Connect the new water tank to HOBOT and
fix the cable along the side of the water tank.
(4) Slide down the new water tank, then fasten the screws.
Care Frequency: when ultrasonic nozzle is clogged and cannot spray water.
Please contact a local retailer or a local authorized dealer for information
regarding replacement parts.
3. Replacing the Ultrasonic Nozzle
※
DO NOT touch the ultrasonic nozzle as they are fragile
(1) Please refer to FAQ Q11 before replacing the ultrasonic nozzle.
(2) Follow the instructions to remove the water tank.
(3) Remove the old ultrasonic nozzle by lifting the silicone ring.
(4) Make sure the cable of the new ultrasonic nozzle comes out from the hole of
the water tank. Then install the new ultrasonic nozzle by pressing the edge of
the silicone ring gently.
(5) Put the water tank back into HOBOT.
Care Frequency: when the ultrasonic nozzle is clogged and cannot spray water.
Please contact a local retailer or a local authorized dealer for information
regarding replacement parts.
4. Cleaning the Caterpillar Belt
Please wipe the accumulated dust off the caterpillar belts frequently to avoid
HOBOT from skidding.
Flip HOBOT upside-down and turn on the power.
The caterpillar belts will continue to run for 3 minutes.
While the belts are running, gently press a cloth onto a
belt to clean it. Keep the cloth in the middle of the belt to
avoid being tangled.
In case the cloth is tangled with the belt, turn off the
power and pull the cloth out.
Care Frequency: Before each use.
---HOBOT---