-
3
-
4.
Plug the mini-USB connector from the cable into the jack on the bottom of the board.
5.
Secure the cable to the board using the cable tie (included).
Feed the tie through the two holes near the end of the board, with the cable tie’s ‘buckle’ on the
battery side of the board. Ensure that cable tie is tight and then trim the end.
6.
Slide the board into the case.
Align the sides of the board with the grooves on the side of the case. Push the board into the case
until the outermost edges of the board are flush with the beginning of the rails.
Gently
pull the
cable where it exits the grommet as you insert the board.
IMPORTANT
: You can press on the end of the board to help guide it into the case, but do not
press on the LED and photodiode leads or they may be damaged.
7.
Re-insert the 3 desiccant packs.
