User Manual -Solar Pumping Inverter
2
Danger: It will cause serious injuries and even death while operating against the rules
Storage Condition:
NOTE
Temperature
Humidity
Temperature -40
℃
to +65
℃
.
5% to 90%, no condensation
Storage in dry, dust-free Do not store in the environment containing corrosive gas, liquid
Installation:
Danger
FORBID to connect the switcher between the Ac output of inverter with the pump
Wire is connected by professional person only.
Each wire connect to the device must be wrapped with electrical tape for safety
Prohibiting the installation location:
direct sunlight, thick dust, corrosive gas or oil mist, flammable
gas, liquid.
Attention
To ensure good convection cooling effect, the device must be installed
Vertically
The height of the device installation should be over 1.1m or more, and please establish the risk identified
beside the device.
The ambient temperature -20
℃
-+60
℃
,
If Over 45
℃
,
Please make sure
well ventilated
and the backside
of inverter should be covered to make sure the air of fan is output from
TOP
of inverter.
Relative humidity 15%-+95%RH
The device ONLY can be used to control the three-phase AC asynchronous
Pump and Resistor Heater.
Attention
If the output flow is small, please exchange the two line of U.V.W
The equipment of the environmental temperature will directly influence the durability and reliability, make
sure the environment to meet the above requirements for prolong the service life of the machine
Maintance:
Danger
Under any circumstances, without professional guidance, do not disassemble the machine or touch the
internal parts
Forbid to maintain the equipment when device is Power-on
