EN
Firebird Stratos
Installing the Tail
To install the tail onto the fuselage of your
aircraft, start by following the two easy steps
below:
1.
Insert the tail into the slot of the fuselage.
Center it by using the centering guides (
A
)
located on the top side of the tail.
2.
Once the tail is in place and centered, apply
8 pieces of tape
(included) to secure it into
position, four on top and four on the bottom.
Attaching the Clevis to the
Control Horn.
Finish the installation of the tail by connecting
the control rod with the clevis on the tail
control horn.
1. Open the clevis and put the pin in the
top
hole
of the control horn.
2. If adjustment of length is needed, hold the
connector with pliers or hemostats and turn
the clevis clockwise or counterclockwise on
the connector.
3. Close the clevis onto the control horn and
slide the tube towards the horn to tighten
the clevis.
A
1
2
3
1
2
Clevis
Control Horn
8
