HobbyZone Firebird Phantom, Руководство пользователя

Страница: 3 / 20

Step
2
Step
1
1. Center the wing on the fuselage by
aligning the center dot on the wing with
the fuselage top seam and by centering
the half circle on the wing’s trailing edge
over the fuselage center.
2. Secure the wing in place by attaching
two rubber bands across the middle and
one on each side as shown. Locate the
rubber bands on the peg hooks as close
as possible to the fuselage sides.
3. Before each flight, make sure the front
and trailing edges of the wing are exactly
centered on the fuselage.
Always make
sure the transmitter is on
when the flight battery is plugged in!
1. Remove the transmitter back cover.
2. Install the included "AA" batteries. Use
four fresh 1.5V “AA” batteries only.
3. Be sure to observe proper polarity when
installing the batteries, and then replace
the cover.
4. To test, switch on the transmitter. The
LED should glow brightly.
5. Replace the batteries when you hear the
low battery alarm (beeping sound).
Note: You may notice a small switch
immediately below the LED and the
power switch. This small switch deter-
mines the controls for the transmitter
with default position to the left. It is
not recommended to change it.
Transmitter Wing Attachment
Rubber Bands (x4)
Needed for Step 2