the end of one of these you are more than likely using the wrong one. Finish off the remaining
horns, clevises and pushrods and come back to it! Also note that for the ailerons, elevators and
rudder, control horns are to be bolted on using the provided M2 nut, bolts and endplates. For the
flaps, use 8mm woodscrews to attach the horns.
Step 5: Preparing for attachment of the tail wings
The tail wings will be glued securely in place using epoxy. First, roughen the surface shown below
using sandpaper to provide a good face for the glue to bond to.
In order to attach the tail wings, 12mm holes must be drilled in the fuselage to allow the servo
wires to pass. Drill these corresponding to the exits you chose to pass the servo wires through in
step 3.
