Slot the wing in place. There is no need to glue. Next, take the landing gear and remove the
cable-tie holding it together. (Note there are small pieces in the landing gear bag that will need to
be kept safe until later, do not lose these)! Place in the slot provided, making sure that the landing
gear is orientated in the correct manner as shown below. Secure with the four screws provided. Do
not over-tighten these!
Install the following two plastic parts as shown. Not again that there is a LHS and an RHS part.
Finally, attach control horns, pushrods and clevises tail and shown below.
Blunt edge to the front,
sharp edge to the back.
