HobbyKing B-17 F, Руководство пользователя

Страница: 5 / 13

H•KING
7
WIRING AND LEADS
1 . Your B-17 comes supplied with a all necessary servo extension/Y-leads and
labeled accordingly. Connect these leads/extensions to their corresponding
leads from the model and into their respective channels on your chosen
receiver.
I
I
I '
Wing LED's Alierons Flaps Gear
t
c
··
Throttle
2. The B-17 also comes supplied with two different types of power leads for either a
parallel connection (using 2x 2200mah 3S pack for a total of 4400mah's) or a power
Y-lead to connect to the parallel one enabling the use of a single 3700-4400 mah 3S.
Please choose according to your preference. See below.
..
� .
..,..,.
Parallel leads Single pack lead
WING INSTALLATION
1. Position the main wing and install on to the fuselage using the wing bolts supplied.
2. Note: You may wish to install and connect your receiver before attaching the wing, as
shown here with the receiver connected and installed directly onto the wing center.
However this will require that you enlarge the hole in the fuselage center section as
illustrated here.
PROPELLER INSTALLATION
1. To install the prop you need to use 3 of the nuts provided. The 1st nut goes all the way
to the end of the threaded shaft. Then slide the prop onto the shaft and over this nut,
using the 2nd nut to secure and the 3rd nut for added security when tightened against
the 2nd nut. The plastic prop dome can now be screwed onto the tip of the shaft. Repeat
for each prop/motor.
NOTE: Ensure props are installed correctly (leading edges of blades should face inwards
towards the fuselage when viewed from the front and confirm correct direction of rotating
(left and right motors should both turn towards the fuselage).