4. Threshold set of protection for low voltage (set a protective value for low voltage)
5. Motor entrance angle set (improve the service efficiency of ESC and the stability in the starting)
6. Accelerated startup set (used in precise gear box and application of helicopter)
7. Helicopter mode (used in application of helicopter)
8. Steering motor (clockwise/anticlockwise)
9. Operating frequency set
10. Protection mode under low voltage (reduces power or halts immediately)
VI. The operation steps of programming in ESC for brushless motor.
Push the pull rod of throttle in the ESC to the highest position to make the ESC enter the setting mode and
then turn on the ESC.
Remark: the ESC enters the setting mode when the pull rod of throttle in the ESC is pushed to the highest
position; the ESC enters the working mode when the pull rod of throttle in the ESC is pushed to the lowest
position.
1) Connect the battery pack to the ESC. After two seconds, a beep shows that the ESC enters the setting mode.
The menu of setting mode is a cycle model. Each function corresponds to one corresponding musical tone.
Each musical tone will ring out for four times continuously. During the four periods when music rings, push the
pull rod of throttle in the ESC to the lowest position. Then the motor will give out a beep to inform that
corresponding parameters have been stored, and the ESC enters the working mode.
2) Repeat the above operation to set various functions you need.
Remark: Can also set with programming panels
（
optional accessories
）
. Refer to specification of
programming panels for setting method.
1. Brake: turn on/turn off
Turn on: the propeller stops immediately when the throttle works under the smallest position.
Turn off: the propeller stops naturally when the throttle works under the smallest position.
2. Battery types: LiPo or NiCd/NiMh
NiCd/NiMh- set protection point for NiCad/NiMh.
Lipo-set protection point for Lipo and detect numbers of battery automatically in the battery pack.
Remark: the choice of NiCad/NiMh battery will make the ESC automatically set the cutoff value of voltage
at 65% of factory defaults. The cutoff value can be modified through the function of protection
for low voltage in case of changes. Once the battery pack of NiCad/NiMh connects to the power,
the ESC will read its initial voltage. The voltage will used as a reference value for cutoff value of
voltage.
3. Protection function of low voltage: low/middle/high
1) In case of Ni-xx battery pack: the cutoff value of voltage is 50%/65%/65% of the initial voltage of
battery pack under low/middle/high threshold value.
2) In case of Li-xx battery pack: the number of batteries can be calculated automatically. Users need not to
set anything except the types of battery. The ESC provides three optional gears for protection point of low
voltage: low(2.8V)/middle(3.0V)/high(3.2V)
For example: the protection cutoff voltage for low voltage is 11.2V as low /12.0V as middle/12.8V as high
in case of Li-po battery pack with four batteries and voltage at 14.8V.
4. Recover to factory default setting.
1) The factory default setting of ESC: