Hobby 10892, Инструкция по эксплуатации

Страница: 31 / 96

15
Should your Biotherm pro not function correctly, please perform a reset:
1. Unplug from mains
2. Plug the mains plug back in while keeping the
button pressed
3. Release the button
Attention: All programmed settings, except those for the clock, are lost. The Biotherm pro will regulate temperature
with factory’s presettings (temperature 1: 25° C / temperature 2: Heating mode 25° C).
7. Causes of error
In the event of a claims issue, please perform a reset to factory settings in the first instance. If this does not eliminate
the fault or error, please identify the fault using the table below:
Error Possible cause Lösung
Display indication E1 Cable break temperature sensor 1 Send device in for repair
Display indication E2 Cable break temperature sensor 2 Send device in for repair
Display indication E3 Error in time settings for temperature control
on slot 1 Ensure that the programmed times do
not overlap
Display indication E5 Error in time settings for temperature control
or timer control on slot 2 Ensure that the programmed times do
not overlap
In the event of a warranty or repair issue, please contact:
Dohse Aquaristik KG
Service department
Reiner Borghold
Industriestrasse 6
33758 Schloß Holte – Stukenbrock
Tel: +49 (0) 52 07 - 92 999 10
e-mail: reiner.borghold@dohse-aquaristik.de
8. Technical data
Operating voltage: 230 V 50 Hz
Connected load for each slot: Max. 2,000 W (ohmic load)
Total connected load of the connection strip: Max. 3,000 W (ohmic load)
Temperature display range: -9.9- 99.9° C
Temperature control range: 0.0- 60.0° C
Temperature alarm range: 1-10° C (00 means ‘no alarm’)
Temperature display accuracy: 0.1° C
Temperature control accuracy: 0.2° C
Connecting cable length: 1.5 m
Sensor cable length: 3 m
Cable control unit - control strip length: 2 m