Hobby Porter HP-007, Руководство пользователя

Страница: 9 / 20

9
Operate with caution in order to avoid damage or injury.
Make sure that the throttle is at its lowest position and the switches are set to their
up position.
Note
Stop operation if any abnormal activity is observed.
Make sure the model does not go out of range.
Danger
Danger
Attention Sources of interference may affect signal quality.
OPERATION INSTRUCTIONS
After setting up, follow the instructions below to operate the system.
POWER ON
BINDING THE TRANSMITTER AND RECEIVER
PRE-USE CHECK
Before operating, perform the following steps to check the system:
1. Check to make sure that all servos and motors are working as expected.
2. Check operating distance: one person hold the transmitter,and another one moves the model away from
the transmitter. Check the model and mark the distance from where the model starts to lose control.
· The range in the specifications was tested without interference from the ground and as a result the range
may vary under different conditions.
Follow the steps below to turn on the transmitter:
1. Make sure that:
· The battery is fully charged and installed correctly.
· The receiver is installed correctly and powered down.
2. Move the power switch to the(On) position.
3. Connect the power supply to the receiver.
1. Turn on the receiver power. Press the SW
switch. The receiver‘s LED should start
flashing.
2. Turn on the
transmitter.
3. When the LED on the receiver becomes
solid, the binding process is completed.
1 2
3
Attention
Keep the transmitter and receiver not over 40 cm
apart when setting and binding.
During the binding process no other transmitter
should be operated in the vicinity at the
same time!