5
16. Single 35” piece of stranded wire is for the
tail brace. The other pairs of wires will be
used later for the main rigging of the
wings.
17. Locate the tail brace parts shown in photo.
You will also need the 35” wire and 2
crimp tubes.
18. Install the U shaped metal over the tail
skid and bolt in place with a swivel on
each side.
19. Slide the wire through one of the crimp
tubes then through the swivel and back
through the crimp. Lock in place by
crimping the tube with a pair of pliers.
20. Thread the wire through the pre-drilled
holes in stabilizer and fin and finish by
repeating the process on the other crimp
21. Attach the pushrods to the rudder and
elevator and adjust to neutral position.
22. Remove the servo hatches from the
bottom of the upper wing.
23. Test fit the micro servo making sure that
the servo arm does not bind on the
opening of the servo hatch.
24. If the servo arm is not centered in the
opening, adjust by cutting the wood
mounting ears for proper fit.
