3
1. Install the full size servo for the elevator in
the fuselage. Place the output shaft end of
the servo toward the tail of the airplane.
2. Install the 9g metal gear servo for the
rudder in the fuselage. Place the output
shaft end of the servo toward the tail as
well.
3. Before installing the servo arms, slip the
pushrods into the fuselage and attach “Z-
bend” end to servo arm.
4. Locate the horizontal stabilizer and the
CA hinges.
5. Insert CA hinges into pre-cut slots in
trailing edge of the horizontal stabilizer.
Insert the hinge 1/2 way into the surface
and put a pin through the hinge to keep it
centered.
6. Slip the elevator onto the CA hinges,
leave a small gap between elevator and
stabilizer.
7. Make sure that the elevator has the
mounting location for the elevator horn on
the right side of the center. The photo
shows the stabilizer from the top view.
8. Check that the elevator is centered on the
stabilizer and that the gaps are even
before you apply the CA to the hinges.
9.
