Hobby Lobby International TEL1600, Руководство пользователя

Страница: 13 / 32

c
6
c
5
c
4
c
3
c
2
c
1
FLAP ASSEMBLY
Place the flap base on the bench, note that you
will need to build a left and a right. Place both
FB’s on the bench in a mirrored orientation.
Mark UP on both base sheets and build them
with this side up. This will assure a left and a
right flap.
Install and glue the horn block (HB) into the
notch provided. Make sure that FB and HB
are flat on the bench.
Pin FB to the bench to stabilise it and install
and glue the flap leading edge (FLE) to the
leading edge in the notches provided. It is a
good idea to use a straight edge to insure it
remains perfectly straight.
Install and glue the 1/4” balsa end ribs (F1).
Install and glue the remaining internal ribs
(F2).
Taper the leading and trailing edge to contour
with the ribs in preparation for installing the
top sheeting.
c
8
c
7
Glue on the flap top sheeting (FS).
After finish sanding the flap, bevel the bottom
3/32” sheeting at a 45° angle to allow clear-
ance for rotation.
11
c
14 Taper the leading and trailing edge to contour
with the ribs in preparation for installing the
top sheeting.
c
15 Glue on the aileron top sheeting (AS).
c
16 After finish sanding the aileron, the leading
edge will need a double bevel, bevel the bot-
tom (from the hinge line down) wit ha 15°
bevel and a 25° bevel above the hinge line.
See the plans for clarification.