❏
1. Trim the covering from over the wing dowel
holes on both sides of the fuselage. The holes are
located at the front and back of the wing saddle.
❏
2. Insert and center the 1/4" x 4" [6.4mm x 101mm]
wing dowels in the holes in the fuselage.
❏
3. Slide a plastic dowel cap over one end of the
wing dowel. Secure the dowel cap with a 2.5mm x
8mm sheet metal screw. Install the other three
dowel caps and secure them with 2.5mm x 8mm
sheet metal screws.
❏
1. Make a strap, the same way you made the
battery strap. Route the strap through the front hole
in the battery tray and back through the middle
hole. Position the electronic speed control (ESC)
on the battery tray and secure it with the strap,
leaving the metal heat sink exposed. Trim off the
excess strap.
❏
2. Connect the red and black wires from the motor
to the red and black wires from the electronic speed
control. Make sure the wires are securely
connected. If any of the metal connector is visible,
wrap it in electrical tape to prevent the wires from
shorting and damaging the electronic speed control.
❏
3. Install the on/off switch in the opening under
the second window on the left side of the fuselage.
Install the Radio
Install the Wing Dowels
12
2.5 x 8mm
