❏
4. Insert the stabilizer and center it in the
stabilizer slot. The side with the red, yellow and
blue stripe faces upward. The two holes through
the stabilizer should be aligned with the fin slot in
the top of the fuselage.
❏
5. Insert the fin in the fin slot. The two threaded
rods go through the two holes in the stabilizer and
out the two holes in the bottom of the fuselage.
❏
6. Place a #2 washer over each fin rod and
secure the fin to the fuselage with #2-56 nuts. Do
not overtighten the nuts and crush the wood. The
nuts should be just tight enough to prevent the
stabilizer from moving side to side.
❏
1. On the bottom of the fuselage, at the aft end,
are two small holes. Remove the covering from
these holes with a hobby knife.
❏
2. Insert the nylon tail skid in the holes. If the tail
skid fits loosely, a drop of glue in each hole will
secure the tail skid.
❏
3. Insert the two main landing gear wires in the
holes, in the slot, at the front of the fuselage.
Install the Landing Gear
10
2-56 Nut
