Hobbico NexStar ARF, Инструкция по эксплуатации

Страница: 18 / 32

❏
2. Wrap the receiver and the battery with foam and then
install them on the radio tray. Use the hook and loop
material supplied to secure them in place.
❏
3. Install a 6" [150mm] extension on the receiver’s aileron
channel. Connect the radio switch to the receiver and the
battery. Use heat shrink tubing to secure the battery connection.
Install the radio tray in the fuselage with two #4 x 3/8" [9mm]
wood screws. Connect all the servos to the receiver.
❏
4. Install the radio switch to the fuselage on the opposite side
of the muffler. If you desire, you can also install a charge jack.
This will allow you to charge the batteries or check their voltage
at the field without taking off the wing. In the instruction manual
airplane we installed an Ernst charge jack.
❏
5. Route the receiver antenna under the servo tray. Install
a retainer on it and then slip it through the plastic guide tube
in the middle until it exits at the aft end of the airplane.
Secure the antenna with tape. Turn on the transmitter and
then the receiver and center all the trims on the transmitter.
❏
6. Cut the elevator, throttle and the rudder servo arms as
shown. Install a Screw-Lock Pushrod Connector on the throttle
and the rudder arm as shown above. Note the holes where the
Screw-Lock Pushrod Connectors are connected.
18