mode. To change modes, switch tester off and restart.
3. Using switch on side of Probe, select "speaker mode,"
"LED mode" or "speaker & LED mode."
4. Use the Probe or any cable tracer to trace the subject
wire. Reception of tone will be loudest (amplifier) or
brightest (LED) on the subject wire.
LANtest Pro Remote ID Operation (available on
model 256656/IDT)
1. Select "Cable" position on the toggle switch.
2. Plug one end of the subject cable into the RJ45 jack on
the master unit and the other end into the RJ45 jack on
the remote terminator.
3. Press the TEST button. One of the ID LED's will flash
three times. This indicates the number of the remote
identification unit attached to the far end of the subject
cable. The tester will then automatically continue with
the same cable test procedure as the standard LANtest
Pro.
Probe Features:
Special inductive plastic tip which prevents accidental
shorts (possible with copper-tip tracers) when using
near high voltage devices
Traces and identifies wires or cable in a bundle or group
without damaging cable insulation
Adjustable volume level for various work environments
Both amplifier and LED for loud or dark work
environments
Can work with any existing tone generator in the market
Probe Specifications:
Pen-style casing
Special inductive plastic tip
One push-button TRACE switch
One battery low LED indicator
One amplifier and one LED for signal detection
One rotary volume level switch
Probe Operation:
1. With the toggle switch on the side of the Probe unit,
select the mode of operation:
a. S & L:
Speaker amplifier and LED tracing mode
b. Sp.
:
Speaker only tracing mode
c. L
:
LED only tracing mode
2. Press and hold the TRACE button while approaching
the subject cable. The intensity of the tone signal will
increase as the Probe approaches the cable.
Product Profile
2
14
12
3
LANtest
Remote Network Cable Tester
TM
Pro
16
15
9
13
LANtest
Remote Network Cable Tester
Pro
TM
REVERSED
SPLIT PAIRS
LOW BATTERY
TEST
MISWIRE
SHORT
11
10
1-2 3-6 4-5 7-8 SHIELD
6
8
7
4
5
1
4
5
256652/LB
1. Master port (RJ45)
2. Pair 1 indicator
3. Pair 2 indicator
4. Pair 3 indicator
5. Pair 4 indicator
6. Shield indicator
7. Short faults LED
8. Reversed faults LED
9. Miss wire faults LED
10. Split pairs LED
11. Battery low indicator
12. Test button
13. ON/OFF switch
14. Battery cover
15. Remote unit
16. Remote test port (RJ45)
