g. Complete the setup and save the setting, then the Main Menu is
displayed.
h. The “Cat5/Cat5e” and “Cat6” mode denotes the LANsmart Pro is
using default factory parameter for testing standard Cat5/Cat5e
or Cat6
cable length
Wire map Test
Before wire map test, user should setup test object (twisted cable, telephone line, or
coax line)
in
Configuration menu.
Connect one end of tested cable to LANsmart Pro main unit, and the other to the
remote.
Select the Cable Test option from the Main Menu, and then select Wiremap,
LANsmart Pro will begin
to diagnose
on the attached cable.
Cable Test
Length Test
Identification
Configuration
ENTER
Wiremap
Twisted Mapping
Short Location
Quick Test
Diagnose
ENTER
(Main Menu)
(Cable test menu)
Transmitting side (main unit)
1 2 3 4 5 6 7 8 G
1 2 3 4 5 6 7 8 G
Open Short Cross Idn
Pass Split Rev
Receiving side (remote unit)
G: Ground/shield layer
Idn: The number of remote
identification unit.
n=1,2,3,4
LANsmart Pro displays cable map results by pin-to-pin. If there are shorts with
shields layer, LANsmart Pro will automatically display it first.
The following explains the Wiremap results in details:
Pin7 and Pin8 are open.
1 2 3 4 5 6 7 8 G
1 2 3 4 5 6 G
Open Id3
Pin2 and Pin5 are short.
5
1 2 3 4 5 6 7 8 G
-
-
Short Id3
