HMS M9239i, Инструкция по эксплуатации

Страница: 23 / 53

4) Attach the Handle Pulse Tube and Computer
a. Insert the Tension control wires (19) through into the hole of the Handlebar support
(7) and then pull them out from the top hole of Handlebar support ( 7). Attach the
Handlebar (8) to the Handlebar locator(A) of the Handlebar post(7) with the Handlebar
cover(69), then insert the Tension control wires(19) into the hole of the Handlebar
support(7) with the Pole plug(70), and put the Spacer(70) on the T-knob(71). Adjust the
handlebar to the proper position, and lock with the T-knob(71) tightly.
b. Connect the Computer wire (18) and the Pulse wires (19), insert the surplus wire into the Handlebar (7). Take Crosshead bolt
M5×10 (74) from the computer (11) ,and use it fix the computer (11) to the top of handlebar support (7). (Refer figure 4)
Note: The latch of the handlebar (8) must be consistent with the groove of the handlebar support (7).
5) Attach the Seat cushion
Attach seat cushion (20) to Seat cushion adjustable bracket (62) with three sets of Nylon
nut M8 (59),
Φ8 Flat washer (55) (Refer figure 5)
6) Attach the Seat Adjustor
First, remove three M8 Nylon Nuts (59) and
Φ8 Flat washers (55) from underneath of the Seat cushion (20), and then attach the
Seat cushion (20) to the Seat cushion adjustable bracket(62) with the three M8 Nylon Nuts (59) and
Φ8 Flat washers (55) that
were removed. (Refer figure 5)
Take out D-shaped washer( below 26 mentioned parts ) from the hardware package, and with the groove of the D-shaped washer
(26) aiming to the slot of the seat support of the main frame (4), pat the D -shaped washer (26) gently into the main frame (4) , and
then insert the Seat bracket (16) to the D-shaped washer (26) and the seat support of the main frame (4); insert the insert the
Seat adjustor (16) into the hole (Refer figure 6). Finally, attach the Seat cushion adjustable bracket (62) to the top of Seat Adjustor
(16) with short knob (64), adjust the saddle support plate to the appropriate position, and then tighten the short knob (64). (Refer
figure 7)