HMS H9249 Series, Инструкция по эксплуатации

Страница: 22 / 37

9). Install the Handlebar (Left & Right)
Insert the Left handlebar (8) to the Left Handlebar support (6L)
with four sets of M8x40 Bolts (33),
Φ8 Arc washers (45), Φ8
Spring washers (51), and M8 Cap nuts (40). Do the above same
steps to assemble the Right handlebar (11) to the right
Handlebar support (6R). (Refer figure 9)
Note: The bolt must be set into the hexangular hole.
10). Install the nut cap
After installed and adjusted the equipment, clip on the cap nut s
at the connecting of U-shape brackets (87), Handlebar supports
(6) and Pedal support tube (4), (Refer Figure 10)
COMPUTER
This
computer’s model is E-239B, with 4-bit
micro processor and single
window LCD (see the left picture) and it has hand pulse sensor.
KEY FUNTION:
A) AUTO ON/OFF : The monitor will be auto-powered when starts exercise
or press the key. The monitor will be automatically shut off if there is no
signal coming in for 4 minutes,
B) SCAN : It displays the values:
①
time
②
speed
③
distance
④
calories
⑤
pulse
⑥
total distance.
The values change every 4 mins.
C) TIME (TMR): Auto-memorize the workout time while exercising (min:sec).
D) SPEED (SPD): Display the current speed (km/h).
E) DISTANCE (DST): Accumulate the distances while exercising (km).
F) CALORIES (CAL): Auto-memorize calories amount consumed while exercising (Kcal).
G) PULSE (PUL):
Display the user’s heart rate per minute while exercising. Remark: You have to
hold on reaction planks with both hands for 4-5 seconds, and then it can display your pulse. The
shinning heart means signal inputs.
H) RESET/CLEAR : To let the value reset.
I) BATTERY: If there is a possibility to see an improper display on the monitor, please replace the
batteries to have a good result .This monitor uses two
”AA’ or ”UM-3” batteries.
ATTENTION: the information only can be recovered in 15 seconds after battery replacement;
the built-in data in computer may be lost after battery replacement; the normal life for battery
is one year.